Tuesday, April 1, 2014

Pintail Finished

I finished the Duckboat a while back but I just have written about it. It was a fairly easy boat to build and excellent first boat to build. I think it was a bit overbuilt, That seems to be a trait among the boats that were drawn by William Jackson. But then, they were mostly working boats built by working men. I chose this boat for stability not for speed. And that is what I got. I intended to use it for photography. And it is excellent for that.

I painted the outside with Rustoleum oil based paint. I only primed the inside. I didn't paint it. I did that to allow the wood to breath. In case the wood does absorb water from a scratch in the outside paint I didn't want it to be trapped by being encased in paint. This is my own opinion and I could be totally wrong but after 15 years of working on boats and wood homes I have seen a lot of rot caused by water getting into wood and not having a way out. This is part of the reason why I didn't fiberglass the hull or encapsulate the thing in epoxy. Eventually, water will find a way in. If it doesn't find it's way back out, rot will happen.

2 comments:

  1. Greg, What kind of plywood did you use for this boat? You said that there was underlayment from the big orange place, and this is the stuff I found.

    http://www.homedepot.com/b/Lumber-Composites-Plywood/N-5yc1vZbqm7/Ntk-Extended/Ntt-Underlayment?Ntx=mode+matchpartialmax&NCNI-5

    http://www.homedepot.com/p/Unbranded-Underlayment-Common-7-32-in-x-4-ft-x-8-ft-Actual-0-196-in-x-48-in-x-96-in-431178/203183010

    My cousin and I are planning on building a similar boat, but we first need to figure out what kind of plywood we could use. Thank you!

    ReplyDelete
    Replies
    1. whoops, I meant to have this for the first link:

      http://www.homedepot.com/p/Unbranded-Underlayment-Common-7-32-in-x-4-ft-x-8-ft-Actual-0-196-in-x-48-in-x-96-in-431178/203183010

      Delete